- Are old radios dangerous?
- Do they still make vacuum tubes?
- Are vacuum tubes dangerous?
- Why are vacuum tubes so expensive?
- Can vacuum tubes explode?
- How long do preamp tubes last?
- Why is my tube amp crackling?
- Are old radios worth money?
- What was the main disadvantage of vacuum tubes?
- Why do vacuum tubes glow blue?
- What does a bad tube sound like?
- Do vacuum tubes glow?
- How do I dispose of old vacuum tubes?
- How do I know when my tubes need replacing?
- What devices still use vacuum tubes?
- What is the difference between vacuum tube and transistor?
- Are amp tubes supposed to glow?
- How much are old radio tubes worth?
- How do I know if my amp tubes are bad?
- What is the best vacuum tube tester?
Are old radios dangerous?
Danger, Danger, High Voltage.
Be very careful when working with old radio equipment.
Yes, these radios have very high voltage potentials inside.
Many even tie the hot end of the line directly to their metal chassis (known as Hot Chassis radios), notably most of the post-war table top radios..
Do they still make vacuum tubes?
Yes, vacuum tubes are still used in some special applications, though not as many as just a few years ago before LCD displays pushed CRTs off the market. Most I can think of are high power radio frequency (especially microwave) devices. One is the magnetron still universally used in microwave ovens.
Are vacuum tubes dangerous?
These types of tubes are readily discerned by a competent trained health physicist, and are not a significant radiation danger, but they are a factor of 10 to 200 times higher than normal background radiation.
Why are vacuum tubes so expensive?
Tube amps are expensive because they adopt pre and power tubes as their primary amplification source. Each tube costs roughly $50 and can have up to 4 of them within a single unit. Secondly, these amps have more expensive components, larger cases, and more complex circuitry than solid-state amps.
Can vacuum tubes explode?
Myth 3: Vacuum tubes explode when broken. We would not be in this business if our products exploded. If broken, a vacuum tube implodes,due to the negative pressure of the vacuum. This means the glass stays put, posing no projectile hazard.
How long do preamp tubes last?
2 – 3 yearsPreamp Tubes are generally at their best 2 – 3 years. Power Tubes are generally at their best 1 – 1.5 years. Rectifier Tubes are generally at their best 3 – 5+ years.
Why is my tube amp crackling?
Is the amp making crackling or popping noises when you’re not playing? If so, this is can be caused by faulty preamp or power tubes. … If no tube substitution alleviates the problem, the amp will need to be serviced, because there’s a good chance it has a failing plate or cathode resistor in the preamp.
Are old radios worth money?
Like many collectible items, radios are subject to fads that artificially inflate prices. … Currently, any radio with a Catalin cabinet may be valued at hundreds, if not thousands, of dollars over the price of a comparable Bakelite set.
What was the main disadvantage of vacuum tubes?
Vacuum Tubes: Disadvantages High power consumption; needs heater supply that generates waste heat and yields lower efficiency, notably for small-signal circuits. Glass tubes are fragile, compared to metal transistors. Sometimes more prone to microphonics than transistors, depending upon circuit and device.
Why do vacuum tubes glow blue?
A tube that is glowing blue is often wrongly perceived as a defect, however, it’s really just a side effect of a power tube — a fluorescent glow in the blue spectrum. The tube is fine! It actually indicates that the vacuum inside the tube is very good, which is what allows this phenomenon to occur.
What does a bad tube sound like?
Preamp Tubes. Preamp tubes usually cause problems through noise or microphonics. If noise, you will hear hiss, crackling, popping or similar issues. If you hear squeal, hum or feedback, it is typically a microphonic tube. Noise from microphonic tubes will typically increase with a volume increase.
Do vacuum tubes glow?
Gas-filled tubes Their distinctive orange, red, or purple glow during operation indicates the presence of gas; electrons flowing in a vacuum do not produce light within that region.
How do I dispose of old vacuum tubes?
Contact the Global Electronics Recycling Network. This group maintains a network of electronic recycling organizations in many countries. Use its website to locate an electronics recycling organization near your home; you can find out the drop-off location and the cost of disposing of your vacuum tubes.
How do I know when my tubes need replacing?
A: These are the most common signs that tubes need replacement: Excessive noise (hiss, hum) including squealing or microphonic tubes. Loss of high end. … A muddy bottom end; Sounds like there is too much bass and note clarity is lost. Erratic changes in the overall volume. … The amp doesn’t work!
What devices still use vacuum tubes?
Other vacuum tube devices include the X-Ray tubes, cathode ray tubes, magnetrons, and photomultipliers. They have found uses and applications even in modern-day microwave technologies used for mobile phones, Bluetooth, Wi-Fi transmissions, and even in radar and satellite communication devices.
What is the difference between vacuum tube and transistor?
Transistor and vacuum tube both are almost same in conceptually. Transistors are used in small integrated circuits which require low voltage supply and Vacuum tubes are used in high power applications. In the manner of size, the transistor is smaller than vacuum tubes. Vacuum tubes are really big and very hot.
Are amp tubes supposed to glow?
A: That blue glow is just a side effect of a power tube — a fluorescent glow in the blue spectrum. The tube is fine! It actually indicates that the vacuum inside the tube is very good, which is what allows this phenomenon to occur. It will not have any effect on the performance or tone of the amp.
How much are old radio tubes worth?
These numbers include 101D ($400+) and 205D ($300+). Other WE tubes include VT1 ($200+) and VT-2/205A ($150+). Any early vacuum tube with a “tip” (the little glass nub on the top) and a brass base has some value to collectors even if it’s just usable for display.
How do I know if my amp tubes are bad?
Symptoms of Bad Pre and Power TubesUnusual sounds coming from the amp..(‘popping’ ‘hissing’ ‘crackling’ ‘humming’)The amps overall volume lower than usual.Individual tubes glowing brighter or dimmer than others.The amp’s tone has degraded (loss of tonal dynamics)The amp will not power on.
What is the best vacuum tube tester?
The Triplett models The Triplett 3444 and 3444A are the top-end versions! Both are excellent tube testers. The difference between them are small. The 3444 is tube operated in that the measurement amp and oscillator are tubes.